Q. Using a T25 torx key and 8mm wrench, unfasten the MRB3 brain
from the vehicle. (Access to the 8mm nut can be found inside the
glovebox.) Once unfastened, disconnect the MRB3 brain to allow for
it to be mounted to the kit provided amp tray.
P. Remove (4) T30 screws that secure the coolant reservoir tank
to the vehicle. Place factory tool kit into glove box. The coolant
reservoir tank / tool kit mounting bracket will not be reused.
Q
P
M. Use an 8mm socket with extension or nut driver to fasten provided
8mm screw and large washer through the factory mounting tab and
into Bracket A.
L. To hold the enclosure in place, screw in a factory T30 screw. Do not
tighten screw.
N. Use 8mm wrench SSV provided 8mm screw and standard washer,
fasten through Bracket B into chassis. Either or To fasten 8mm
screw and standard washer through Bracket B, use 8mm wrench.
Once each bracket has a screw threaded, tighten down each screw.
M
L
N
O. Hold the pod into place and fasten the (2) T30 screws back into the
pod that were removed in Step C. Route speaker cable back into dash
cavity. Reconnect the harness. Route speaker wire to sub enclosures,
avoid any moving or rotating parts. Reassemble vehicle
O