SSV-10M
© 2016 SSV Works, Oxnard, CA 93030
SSV-10M Rev. A 2-12-16
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct connect the “+” to the “+” and the
“-“ to the “-“from the speaker wire to the amplifier. If using with an SSV Works complete
system refer to the amplifier wiring instructions for more detailed wiring information.
“+”
“-”
“-”
Amplifier
1. Place the SSV-10M
in the enclosure to
verify fit and center
the subwoofer in the
enclosure cutout.
2. Mark the 8 mounting
holes with a scribe or
marker
3. Pre-drill the 8
mounting holes with
the 1/8” drill bit
4. Connect and install
the speaker into the
enclosure using the
#2 Phillips screwdriver
(be sure to connect the
“+” speaker wire to the
“+” terminal on the
speaker and the “-“
speaker wire to the “-“ terminal on the speaker) (NOTE: All 8 screws must be installed and
tightened to properly seal against the enclosure and ensure the best sound)
5. Route the speaker wire away from any moving parts and any sharp metal, then connect to
the amplifier