WWW.SSTCOMM.COM
19
Assign IP Mode
: Manual Assign, BOOTP, DHCP optional;
IP Address
: Set the IP address of the GT200-HT-MT;
Subnet Mask
: Set the subnet mask of the GT200-HT-MT;
Default Gateway
: Set the gateway address of the GT200-HT-MT;
DNS1
: Default 0.0.0.0;
DNS2
: Default 0.0.0.0;
5.2.2 Configure the HART Fieldbus
5.2.2.1 Set the Parameters of HART Channel
Click the "HartChannel0" on the left, then the configuration plate will be shown as below:
Master type
: Primary master, Secondary master optional;
Network mode
: Select the network mode of HART. In “point-to-point” mode, only one HART instruments of
