6
Application
Table-top accessory for MOM/
MOC 711-..., in conjunction with the
system telephone T 611-0, T 611-10
or SIC 3000-..., for conversion of a
wall to a table-top device. Slip-proof
console with 2 rubber feet.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Modern furniture is coated with an
enormous variety of different lacquer
and plastic finishes. Constituents of
these materials can result in sof-
tening of the plastic feet in table-top
devices and so impair the surface of
the furniture. Please appreciate that
the manufacturer is unable to accept
any liability.
Mounting
1
Remove upper part of housing
from system telephone and monitor.
2
Remove knockout “a“ in the
bottom part of T/SIC... and MOM/
MOC 711-... and use the 2 con-
necting elements supplied with the
monitor to bolt the components
together.
English
3
Insert the connection wires of the
ZTMO 711-... through the cable
opening in the baseplate. Attach
the brackets to the bottom of the
housing as shown and glue the 2
rubber legs supplied in the holes
provided for this purpose in the
lower sloped surface of the monitor.
4
Connect the leads as per terminal
diagram ZTMO 711-... Please place
unused wires in the bracket.
5
Connect the ZTMO 711-... to the
HT 611-01.
6
Connect the ZTMO 711-... to
the combination SIC 3000-... with
MOM/MOC 711-...
7
Connect the ZTMO 711-... to the
combination T 611-10 with MOM/
MOC 711-... In combination with
the system telephone T 611-10 see
Product Information
ZT 611-10.
8
Connect the ZTMO 711-... to the
combination BTS/BTC 750-... with
MOM/MOC 711-...
9
Plug the weak current plug and
2-pin flat connector on the coaxial
cable, onto the mother board and
shut the housing halves.