10
Remote programming
Programming remarks
only possible as long as a number
has been allocated to every appli-
ance in the system. This is of par-
ticular importance during initial
commissioning.
If either of the two call stations
has a power failure during remote
programming, both call stations
are returned to the basic status
after an automatic reset.
Remote programming
Using any optionally selected
intercom SIC/ICI 3000-01 call sta-
tion, it is possible to program any
of the appliances connected to
the system bus. However, this is
Programming remarks
In the programming menu,
the menu points appear in the
sequence listed on page 5. It is
possible to scroll through the list
forwards with the R button and
backwards with the F button until
you reach the required point.
If you do not wish to change a
value indicated in the display, sim-
ply scroll to the next point with
the F or R button.
If you do wish to change a set-
ting, enter the required value and
then continue to move through
the menu.
Remark:
This procedure is practically iden-
tical for every point appearing in
the menu.
Here, it is possible to define the
required functions at each menu
point by entering “0, 1“ or a
number combination.
There is no need to confirm
inputs.
When you scroll to the next
menu point, your inputs enter
an intermediate store.
After leaving the programming
mode (with the C button), the
inputs are stored and become
valid as a result of an automatic
reset of the programmed call sta-
tion.
Press the R or F button
Enter “0, 1“ or a number
sequence
Press the R or F button
1
0
F
R
F
R
