7
Programming –
manual (Mod. 2)
BVM 650-0
Bus-Video-Modulator
Bus video modulator
Modulateur bus vidéo
Prog. Mod.
Mod.
1
2
Status
IP 20
Bregstraße 1
78120 Furtwangen
Germany
2
At the BVM 650-… hold the
programming button down for
4 seconds. After this, the status LED
flashes at short intervals as long as
the programming mode is active.
The BVM 650-… with switch posi
-
tion 2 is used for connecting an
external camera without door sta-
tion to the Siedle In-Home bus:
Video.
External camera dialling can be
programmed as a function on a bus
telephone button.
This function can be programmed
for any bus telephone to any button.
The only exception is the door
release button.
1
Switch on the programming mode.
At the BNG/BVNG 650-…, press the
programming mode button briefly.
The LED 1 flashes in a 2-second
rhythm to indicate that the program-
ming mode is active.
6
Replace the receiver. Continue to
program more bus telephones or
quit the programming mode.
5
At the bus telephone, hold down
the button you wish to use to call
the external camera for 4 seconds.
Replace the receiver at the bus tel-
ephone. The button is now assigned
to the external camera. The external
camera can be selected at any time.
4
Hold down the light button for
4 seconds. A protracted signal tone
is audible in the receiver. The bus tel-
ephone is now in the programming
mode. Do not replace the receiver!
The camera picture can be seen on
the monitor.
3
Lift the receiver at the bus tel-
ephone which you wish to program.
