SSP North AB
30/08/2018
Manual V2f
28
Joining two Safety Simplifier enclosures
together
Two or more Safety Simplifier enclosures can be
joined together (see Figure 5.1) using the special
connection screw (see Table 5.1: Accessories for
mounting and installing Safety Simplifier on page
28). This is done by aligning the bottom part of one
Safety Simplifier with the top of another and
screwing the connection screw through the bottom
Safety Simplifier into the top Safety Simplifier.
Make sure the alignment pins of the bottom
Simplifier are aligned with the corresponding holes
in the top Simplifier.
Screw with sealing
M5 with O-ring for mounting of Safety Simplifier
SP-N-88-001-89
M16 Plug (yellow)
Plug with O-ring for mounting from outside
Plug for inside mounting on top part when two boxes
are connected together
SP-N-88-001-73
SP-N-88-001-60
Connection screw
with sealing
Plastic part with threads M16 and O-ring
SP-N-88-001-90
Table 5.1: Accessories for mounting and installing Safety Simplifier
Note
Do not forget the O-ring sealing when joining two Safety Simplifier together with the
connection screw, as shown in Figure 5.1.
Make sure the alignment pins of the bottom Simplifier are aligned with the corresponding
holes in the top Simplifier.
Figure 5.1: Joining two Safety Simplifier enclosures
using the connection screw (see Table 5.1:
Accessories for Safety Simplifier on page 28).
A: top Simplifier
B: bottom Simplifier
1: O-ring sealing
2: Connection screw
3: Alignment pins
