1.8 UNIT INSTALLATION
INSTALLATION INSTRUCTIONS
TO B OOS T UP THE CAPA BILITY O F
ANT I-JAM MING, PL EASE FIX THE
METAL ST RAP ON T HE M ETA L
CON NEC TED TO TH E BO TTO M
BRA CKET OF THE C AR.
METAL ST RAP
DAS H BO ARD
SLID ING M ETAL HOUSIN G
TO DRAW THE CHA SSI S OU T OF
THE SLIDING METAL HOUSI NG,
INSERT THE LEFT AND RIGHT KEY
PLATES INTO THE RIGHT POSITI ON
OF THE 2 SID ES O F CH ASSIS.
PLAS TIC T RIM OUT
UN IT CH ASS IS
SELE CT T HE P ROP ER TAB
FOR FIXIN G TH E SLIDIN G
METAL HO USI NG.
TH E UNIT IS INS TALLED T O BE AN A NTI- THEF T ONE. T HE C HASSIS
O F THE UNIT WEARS A SL IDIN G METAL HOUSING . PLEASE DO THE
C ONNECTION O F TH E PO WER, SPE AKE RS A ND A NTENNA ACCORDI NG
TO THE REQ UIR EME NT O F TH E INS TRU CTION BOOK , THEN INSTALL
TH E SLIDING METAL HOU SING IN T HE C AR A S FO LLOWS.
F RON T PAN EL
It is for adjusting the hue of the video output.
It is for adjusting the saturation of the video output.
It is for adjusting the sharpness of the video output.
It is for selecting your desired sound effect when there is not central speaker
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose the
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose this item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose this item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
It is for selecting audio output mode
LINE OUT: It can compress the audio signal. So the volume level is lower.
RF REMOD: It can make the volume level higher.
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
It is for selecting a desired audio output mode for the left and right ways of signal.
It is mainly for Karaoke of Ac3. There are 4 modes in all as follows:
STEREO, MONO L, MONO R, MIX MONO.
HUE
SATURATION
SHARPNESS
4.24.5 SPEAKER SETUP
4.24.6 DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
DOWNMIX
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com