Using 3/4” (19mm) electric, vinyl or plastic tape to wrap
the connection, starting at the cable side at about 1”
(25mm) from the connector. Overlap the tape to a
half-width. Extend the wrapping to the antenna connector
base.
2.
3.
4.
Cut a piece of butyl rubber large
enough to wrap around the
connector and extended past
the first layer of tape.
Stretching it so that it will wrap
completely around the
connector and cable. Press the
rubber against the connection
and cable, ensure there are no
gaps at the edges.
Start below the rubber, using electric, vinyl or plastic
tape overlapping at half-width, wrap up towards the
base of the antenna connector. Repeat this process to
create 4 layers, each layer should start 1” (25mm) below
the previous layer. After completing each layer of tape,
check your work to ensure there are no places where
water can collect. If there are, you must smooth out
those areas.
Quick Installation Guide
