SSF BAT 2, Manual

Page: 7 / 16

7
Short push of adjustments- and On-/Off-button
switches on the mode “Volume” in which you can adjust
the volume. This function ends automatically after 5 sec.
with no push.
Adjust the volume by pressing the and button (16 stages). Graphic on the right
side of the LCD shows the current stage.
Use Up-/Down-button and in normal-mode for adjustment of mixer frequency
for Heterodyne-receiver. With every push frequency changes by +/- 1 kHz, while a
longer push switches to fast run. Frequency, resulting of mix of ultrasonic frequency
and appointed mixer-frequency, will be transmitted via speaker (or headphones).
Adjustment of frequency is continuously variable from 15 kHz to 130 kHz.
Parallel to mixer-mode the SSF BAT2 is also scanning the whole spectrum for
ultrasonic frequencies using frequency division. The located frequency will be displayed
in a graphic. At the same time, strongest located frequency will be displayed on the
right (peak-frequency).
Through short push of frequency-button this located
peak-frequency will be taken as mixer frequency and
hearable.
Through long push of frequency-button one of the
programmed and stored fixed frequencies will be taken
as mixer-frequency using the heterodyne-receiver.
Dot to the right of the fixed frequency shows frequency which will be taken next.
While pushing dot always jumps to the next stored frequency. Storage space not used
(display: „000“) will be skipped.
3 frequencies are programmed as a default setting:
20 kHz, 40 kHz und 45 kHz
Fourth storage space is left empty. See chapter „
Store “ at the end of this page for more
information about programming of fixed frequency.
Volume setting
Adjustment of mixer frequency
Use of frequency division & heterodyne
Use of fixed frequencies
040
kHz
VOL
020 .
040
045
000
V o l u m e
038
kHz
2 3 4 5 6 7 8 9 0 1 2
038
VOL
020 .
040
045
000
020
kHz
2 3 4 5 6 7 8 9 0 1 2
038
VOL
020
040 .
045
000