Page 8
INSTRUCTIONS
COMBINING BREW CUBES
1. Refer to the Brew Cube Product Guide for
assembly of the first Brew Cube. The top and
bottom holes on one side of the Brew Cube will
be used for the attachment hardware. Silicone
Hole Plugs will not be needed on this side.
2. For the second Brew Cube, use (2) 3/8”-16x2-1/4” screw and washer assemblies in place of two
Threaded Feet as shown above. The top and bottom holes on one side of the Brew Cube will be used
for the connection hardware. Silicone Hole Plugs will not be needed on this side.
3. Lay both Brew Cubes on their side and assemble the (4) 3/8”-16x3-1/2” screw, washer, and nut
assemblies on the top and bottom holes as shown. Wait to fully tighten the hardware until all four
screws have been installed. Fully tighten the hardware until just past snug. Do not overtighten.
