SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
Controls and indication
1.
DMX input signalization
2.
DMX input connector channel A
3.
Termination indication
4.
A/B channel selector switch
5.
DMX output data signalization
6.
DMX output connector
Device Design
Front panel:
Rear panel:
Device use/servicing:
The ON LED indicator indicates the device is on the main power. All other DATA indication LEDs being
off mean no incoming signal. The termination LEDs are ON when the termination switch is activated.
The desired DMX source to be retransmitted on each output can be selected using the A/B switches
close to the output connectors.
When the DMX cable is connected to the device, all LEDs marked as D+/D- or the sign of signal
polarity go ON. This indicates that DSR10AB is functioning properly and is retransmitting the input to
the outputs. If any of LEDs is off, check the cable first – short circuit on a line causes the respective
LED is off.
