( 2 / 4)
IMPORTANT SAFETY INFORMATION
The following general safety precautions have to be observed during all phases of operation,
service, and the repair of this equipment. Failure to comply with these precautions or with
specific warnings in this manual violates safety standards of design, manufacture, and the
intended use of this equipment.
Do not operate in an explosive atmosphere!
Do not operate this equipment in the presence of flammable gases or fumes. Operation of any
electrical instrument in such an environment constitutes a definite safety hazard.
Water, moisture, heat and humidity
Do not operate this equipment near water or in areas with wet floors or in high humidity
atmosphere where condensation forms on the equipment. It should never be placed near or over
a heat register or other source of heated air and it should not be installed or operated without
proper ventilation.
DMX connections
DMX RJ45 connectors are located on the front panel of the device. Splitter consists of DMX in,
thru and outputs marked as A-J. These outputs are optically/electrically isolated and equipped
with RDM filter on each output. Both input lines should be terminated by the termination switch
marked as “120R”. When the line is terminated by the 120R resistor, RED LED indication is on.
There is also a bus line driver indication of signal on both signal lines with two LEDs indicating
the polarity of the DMX signal.
Pin 1, 3
Data +
Pin 2, 6
Data -
Pin 4, 5
NC
Pin 7, 8
Ground / Common