SR
SYSTEM-ELEKTRONIK GmbH
|
Eschachstr. 23
|
D-78078 Niedereschach
|
phone +49 77289268-0
|
Seite | 18
Operation and repairs
•
Displaying a still image for a longer period of time can lead to image sticking problems (see
our notes on the support area on the Internet at FAQ).
•
Before opening the device, switch it off and disconnect it from the power supply.
•
supply voltage.
The opening is to be carried out only by authorized technical personnel!
•
Please note that high residual voltages may still be present in the device even after the
supply voltage has been switched off or the mains plug has been disconnected.
Unintentional contact with charged components and contacts can lead to electric shocks and
damage to the device.
•
Do not insert any objects into the device. Foreign objects of any kind inserted through the
housing can lead to operational safety hazards and cause damage to the device and to
persons.
•
Do not spill any liquids inside. If this should happen, however, disconnect the device from
the power supply immediately. There is a risk of fire if operation continues.
•
Only install system extensions that are compatible with your system. Other extensions may
damage the device or change the EMV behavior.
•
Important:
If additional components or other modifications are subsequently installed on the device,
the declaration of conformity within the scope of the CE marking is invalid and the operator
is responsible for any problems that may occur.
•
Stop operating the unit immediately if you notice anything abnormal, such as smoke, noise
or odor. Disconnect the power plug and clarify the cause of the malfunction before
operating again.
