SRK Electronics FMA501, Manual, Page: 15 / 33

SRK Electronics FMA501 manual
 2007 SRK Electronics Pty Ltd 14
Running<LF><CR>
(response from amplifier indicating that it is running)
>
PC?<CR>
Returns the current PSU cut status. For example:
PC?<CR>
(command)
Off<LF><CR> (response from amplifier indicating that PSU cut is off)
>
or
On<LF><CR>
(response from amplifier indicating that PSU cut is on)
>
BS?<CR>
Returns the current self test status in the form XXXXX<LF><CR>>, where X can be either 0
or 1. A 1 indicates a failure, a 0 indicates a pass. The first byte indicates line volts high, the
second indicates line volts low, the third indicates high temperature, the fourth indicates a
high input RF condition, the fifth indicates a high SWR condition and the sixth indicates a high
RF output power condition. For further information consult the section on protection. For
example:
BS?<CR
>
(command)
000010<LF><CR>
(response from amplifier indicating a high SWR condition)
>
or
000000<LF><CR> (response from amplifier indicating no failures)
>
FE<CR>
Unlocks the front panel to allow parameters to be altered locally. For example:
FE<CR>
(command to enable the front panel)
Ok<LF><CR> (response from amplifier indicating that command has been
> executed)
FD<CR>
Locks front panel. Parameters can be measured but not changed locally. For example:
FD<CR>
(command to disable front panel)
Ok<LF><CR> (response from amplifier indicating that command has been
> executed)
SD=XX/XX/XX<CR>
Sets the date according to XX/XX/XX. For example:
SD=23/07/06<CR> (command)
Ok<LF><CR>
(response from amplifier indicating that command has been
> executed)
ST=XX:XX:XX<CR>
Sets the time according to XX:XX:XX. For example: