Installation of the Vacuum Pump Interface on the
SRI 8610C GC
Run the fuseholder wire, the white
wire and .5meter long length of the
green/yellow wire out through the
hole in the chassis. Slide a sec-
tion of heat shrink tubing onto
each wire before soldering to the
power jack.
The fuseholder wire is connected
to the terminal marked ‘L” ( line )
The white wire is connected to the
terminal marked “N” ( neutral )
The green/yellow wire is soldered
to the middle terminal which is
marked with the ground symbol
Secure the jack in place with two
screws and locknuts. Use a stick-
pad and tiewrap to secure the
fuseholder near the jack.
December 2009
Page 6
SRI Tech Support 310-214-5092
www.srigc.com
