SRAM RockShox Vivid Air R2, Technical Manual, Page: 17 / 27

GEN.0000000003161 REV A 17
Remove and replace the glide ring and quad-ring 55.
seal located on the IFP.
Use a T10 TORX 56.
®
to remove the IFP bleed screw.
Use a pick to remove and replace the IFP bleed
screw o-ring.
Set aside the IFP reservoir, IFP, and IFP bleed 57.
screw until you get to the Shock Bleed &
Reassembly section.
R2C onLy: LoW SpEEd CoMpRESSion vALvE
SERviCE (CoMpREhEnSivE SERviCE)
Use a 2 mm hex to loosen, but not remove, the 58.
the Low Speed Compression knob set screw.
Remove the Low Speed Compression knob.
Squeeze the Low Speed Compression valve 59.
assembly between your fingers, and carefully
push it up and out of the IFP reservoir base. Set
the assembly aside.
Continue to squeeze the compression valve
assembly together as you remove it to prevent
the detent ball and spring from getting dislodged.
Remove and replace the reservoir base o-ring. 60.
once the o-ring is seated, apply a small amount
of grease to the visible o-ring surface.
Separate the inner knob and detent ball and 61.
spring from the Low Speed Compression valve
assembly.
Slide the check spring and shim off the valve 62.
assembly. Inspect the check shim for damage
and replace it if necessary.
if the check shim needs to be replaced, do
not use a pick to remove it. instead, use your
fingernail to avoid damaging the valve sealing
surface.
Use your fingers to unthread the compression 63.
needle from the back of the Low Speed
Compression valve assembly.
SERviCE inSTRuCTionS (ConTinuEd)
59 60
61
55
58
56
62
63