Model SRV714 Series
Operating and Service Manual
Part No. MAN714_200601
Page 10 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
Copyright 2020
S
Instruments, Inc.
BASIC SYSTEM OPERATION (CON’T)
BUTTON FUNCTIONS
The “
WEIGH
” button will display weight in pounds or kilograms as selected.
The “
Held Wt
” button allows access to the last stable weight that was achieved.
The “
ZERO
” button is used to zero the system.
The “
POUNDS
” button allows weight data to be viewed in pounds, displayed in a resolution of
5 pound intervals.
The “
KILOS
” button allows weight data to be viewed in kilograms, displayed in a resolution of
2 kilogram intervals.
BATTERY REPLACEMENT
When battery replacement is needed, an indicator will appear on the display.
STEP 1:
Remove the center Top Panel (Figure 4) and disconnect the two (2) cables from the
Transducers. Turn the Top Panel over and remove the four (4) Display Cover screws and the
clear plastic cover from the Display housing. Unscrew the two thumb screws on the Battery
Cover and remove the battery cover (Figure 7).
STEP 2:
Remove and replace all six (6) “D” cell batteries. Replace the Battery Cover and tighten the
two thumb screws.
STEP 3:
Place the clear plastic cover on the housing and secure with the four (4) screws.
NOTE:
Tighten screws only until rubber seal starts to compress.
STEP 4:
Connect the two (2) cables from the Display housing to the Transducers.
STEP 5:
Press the “
ZERO/ON
” button on end of Transducer tube and confirm display is working.
STEP 6:
Set the Top Panel back in place by sliding it down over the Transducer assembly pins.
Battery Cover
Display Cover
Figure 7: Display Assembly