Do not use machine if it has been sprayed with water or left out in the rain. This could result in a shock injury.
Keep feet, hands, and loose clothing away from any moving parts on the machine to avoid injury. Disconnect
power cord before changing the pad or when servicing.
Caution:
Damage can occur to the machine or to other property if instructions in the owner’s manual are not followed.
Warnings:
Do not operate this machine while under the influence of alcohol or other drugs.
Never allow children under age 18 to operate this machine.
Unplug machine from power source before adjusting height of handle or changing pad.
Never attempt to move the machine by pulling the power cord.
Transport of Machine
To transport this machine, the following procedure is advised:
- Unplug machine from power source.
- Always leave a pad on the machine to protect the grip face from damage in transport and storage.
- Wrap cord using cord wrap and handle.
- Raise handle and lock in upright position.
- Tilt machine onto wheels and transport slowly.
- When lifting machine, it is advisable for two users to participate. With one user on each side of the machine, grip
lifting bars at the base of machine with one hand. Grip the handle with the other hand and lift.
- Secure machine when transporting in a vehicle to prevent movement.
Caution:
This machine is very heavy. Get assistance when lifting. Do not attempt to lift alone.
Operating Instructions
1) Move machine to work location. Never transport or store the machine without a pad to protect the grip face.
2) Check the pad. If it has become reduced to a thickness of less than ½” replace the pad.
3) To install or replace pad, follow these instructions:
- Make certain power source is disconnected.
- Lock handle in upright position.
- Tilt machine back until the handle rests on the floor.
- Remove existing pad and replace with new pad. Center pad when placing on grip face.
- Press pad firmly into grip face.
- Return machine to upright position.
** When using a Surface Preparation abrasive pad, place the pad on the floor and slowly lower machine onto pad,
making certain the Surface Preparation pad is centered on the machine and red pad.
4) Connect cord to power source.
5) Release and lower handle to a comfortable position. Lock handle into position. The best operating position is at
arm’s length to help with control of machine and to improve operator comfort. Maintain the machine flat on the
