Important notes
Only use the SQOOM system with
the treatment gels developed by
Schick Medical.
Do not treat one area for longer
than 20 minutes a day.
Do not apply SQOOM to areas
of skin affected by skin cancer or
surgery.
Do not apply SQOOM when wearing
a cardiac pacemaker.
In cases of thyroid hyper
function, do not apply SQOOM to
the front of the neck or chest area.
Do not apply SQOOM near joint
implants, as this may cause pain.
Do not use SQOOM on the abdomen
or chest area during pregnancy.
Avoid contact with the eyes.
Keep the device and the gel/cream
away from children.
Do not store the gel/cream at tem-
peratures exceeding 25 ºC.
The gel/cream is intended for skin
application only.
If you are treating someone else
with your SQOOM, be sure to touch
them with your free hand (skin
contact) to ensure proper operation
of the system.
© All rights reserved by the
Schick Medical GmbH.
All content is subject to copyright.
Schick Medical GmbH, D-78628 Rottweil
CE, ISO 9001 2000, UL-C, US, UFD,
HS Mark
Guaranteed for 2 years.
Technical specifications
Device name
Device LFC-06
Series KTL-SF0700-6001
Charging station
Line voltage
AC 100-240 V, 50/60 Hz
Weight
133 g
Hand set
Lithium/Ion battery
Line Voltage
AC 100 V bis 240 V
Output/Adapter 4.2 V = 1 A
Output
7 W
Weight
194 g (gross)
Ultrasound
Frequency
1 MHz
Intensity levels from 0,1 W/cm
2
to 0,5 W/cm
2
Ionisation
1 Hz/150 µsec
pulse range
For recycling reasons, the device
should not be disposed of with normal
household waste at the end of its service
life. You can dispose of the device by
returning it to Schick Medical GmbH or
corresponding collection points.
23
Please observe the following instructions
for a long service life of your device.
Maintenance, recharging and environmental
protection
22
·
Store in a dry place and do not
wash with water.
·
Clean the transducer with a
damp cloth.
·
Place the device into the
charging dock after switching-
off and make sure the red LED
light glows.
·
The red LED light turns green
when the charging process has
been completed. In the case of
charging errors, the red LED will
flash.
·
If the battery is completely
empty charge it for at least 3
hours before using the device
again.
·
When completely charged
the power will last for
approximately 4 hours.
·
Keep the STEP button pressed
for about 3 seconds to indicate
the charging status of the
battery. If the 6 LED programme
lights glow the device is fully
charged. If only 2 LED lights
glow, the remaining battery
power is 30 minutes. A signal
tone indicates the battery
needs to be recharged.
·
The device will automatically
switch-off after 2 minutes if not
in use.
·
The preset application time of
each step is 4 minutes. A signal
tone sounds after 4 minutes
and the device switches to
standby mode. The device will
switch-off completely if not
reactivated within 2 minutes.
·
The nominal input voltage is
100-240 V AC, meaning that you
use the device while travelling
everywhere around the world.
·
Remove the power plug from
the charging station as soon as
the device has been charged
completely.
·
Always keep electrical contacts
clean, free of dust and dry.
