1009104 Rev. A
©2012 Brinly-Hardy Co.
9
6. Travel to spreading location.
7. Ensure area surrounding spreader is clear of bystanders.
8. Engage Speed Control Lever to ensure speed is 3mph.
9. Push Hopper Shut-Off Lever to the OPEN position.
10. Evaluate spread pattern.
11. If spread pattern is OK, continue to spread at
recommended speed of 3 MPH.
12. If spread pattern needs to be adjusted, go to Accuway
Spread Pattern Adjustment Section.
13. Pull Hopper Shut-Off Lever to CLOSED position. Close the
gate of the spreader while still at operational speed.
ACCUWAY SPREAD PATTERN ADJUSTMENT
As you spread, if the spread pattern is skewing or fl owing
heavy to one side, simply pull the Accuway Spreader Calibration
Lever rearwards until the Accuway is located underneath the
hopper hole as shown below.
Travel
Spread
Pattern
New
Spread
Pattern
Set
Accuway
to:
Heavy to
Left
Heavy to
Right
Moving the Accuway plate shifts the material on the spinner.
Adjustment is very sensitive and should be done in small
increments until the spread pattern is centered.
SPREADING CHART
This unit is designed to handle dry, clean, free-fl owing material
only such as bagged rock salt, ice melt, fertilizer, and grass
seed.
SPEED - ACCURACY - FREEDOM FROM STRIPES AND STREAKS
are yours - when you use this Spreader. The spread width
ranges from 6 ft. to 25 ft. wide, depending on the volume/
density, particle size of the material and the rate of travel.
The spread thins or feathers at the outer edges, eliminating
sharp, “Edge of spread” lines which cause stripes and streaks.
REMEMBER- Published dial settings can be approximate only.
The operation of the spreader, the condition of the material
(damp or dry or over-pulverized) and weather conditions, are
all contributing factors. For these reasons, it’s often a good
idea to spread the area 2 times - at one-half rate - in cross
directions. Vehicle travel speed should be 3 MPH.
CAUTION. Avoid injury! Chemicals can be dangerous. Avoid
injury to operator or bystanders.
•
Read chemical MSDS (Material Safety Data Sheets) and
container label for proper/safe handling instructions.
•
Wear appropriate clothing and safety equipment when
applying and handling chemicals.
•
Prohibit smoking, drinking, and eating around chemicals.
WARNING: When spreading products containing herbicides,
exercise extreme caution with respect to
careless spreading and to wind-drift. CONTACT OF SOME
PRODUCTS ON SOME PLANTS CAN BE FATAL.
