Note: If the maximum number of events have
been recorded, the meter displays FULL. Refer to
the Setup Menu: Erase the Memory procedure to
clear the events.
2. Press to record an event. Press the
button again to stop recording.
Using the Infrared (IR) Thermometer
CAUTION: To prevent personal injury, do not stare
into the laser beam. This is a Class 2 laser product.
1. Plug the output of the IR thermometer into the
IR input on the side of the TIF3340. IR TEMP
appears on the display.
2. Aim the IR light at the location to measure.
3. Press . The temperature appears in the
tertiary display.
Shutting OFF the TIF3340
1. Press and hold the button while the
secondary display counts down from three
to zero. The thermometer shuts off after the
display reaches zero.
NOTE: If the sleep timer (SLP) is enabled, the
thermometer automatically shuts down after
twenty (20) minutes of inactivity.
Sheet 2
Holding Displayed Readings
1. Press to freeze the displayed readings.
The display shows HOLD.
2. Press to toggle the T1, T2, IR, T1-T2,
T1-IR, and T2-IR readings in the primary,
secondary, or tertiary display.
3. Press for two seconds to toggle the T3,
T4, IR, T3-T4, IR-T3, and IR-T4 readings in the
primary, secondary, or tertiary display.
4. Press for two seconds again to return to
the original display.
5. Press
HOLd
to turn off the HOLD option.
Viewing MIN, MAX, and AVG Readings
1. Press to step through maximum (MAX),
minimum (MIN), or average (AVG) readings.
The display shows elapsed time since entering
MAX / MIN / AVG mode, or the time at which
the minimum or maximum occurred.
2. Press for three (3) seconds to exit.
Recording Data
OPERATING INSTRUCTIONS contd.
1 0000
1. When the meter is turned
ON, the number of events
that may be recorded is
shown on the secondary
display.
