Operating Instructions, Form No. 1000031, Back sheet 2 of 3
INSTRUCTIONS FOR CONVERSION TO 13-HCR TOOL
1.
Fully retract tool ram and make sure all pressure has dissipated.
2.
Place tool in a vise with handles pointing upward. Remove adhesive label covering slot in cylinder.
3.
Pry hooked end of retaining wire out of slot in cylinder.
4.
Holding hooked end of wire with pliers, rotate cylinder to force retaining wire out of groove and through slot.
Discard wire.
5.
Carefully separate pump assembly from cylinder assembly, holding discharge spring in place.
6.
Apply lubricant to groove in end cap of remote tool and to retaining wire.
7.
Insert end cap into back end of cylinder assembly. Rotate cylinder assembly until hole in end cap appears in
slot in cylinder.
8.
Place hooked end of new wire from conversion kit into hole in end cap. Align free length of wire along slot
in cylinder. Rotate cylinder assembly in opposite direction to feed wire through slot and into groove.
9.
When wire is fully engaged, hooked end will snap out of hole in end cap to permit full head rotation.
Wedge spring pin in slot in cylinder, allowing wire to move freely beneath. Seal slot with new adhesive label.
10.
Purge air from remote tool and pump system using normal fill and bleed procedures.
WIRE SLOT IN CYLINDER
13-HHC TOOL
CUTTER HEAD SUB-ASSEMBLY
(PART NUMBER 4-0929)
REMOTE END CAP ASSEMBLY
(PART NUMBER 4-0765)
CONVERSION ASSEMBLY
(PART NUMBER 4-0766)
1-RETAINING WIRE
1-WRAP AROUND DECAL
Sheet No.
3 of 7
Rev
Date: 12 Feb 2004
®
SPX Corporation, Rockford, IL 61109 USA
http://www.powerteam.com
Made in USA
®
SPX Corporation, Rockford, IL 61109 USA
http://www.powerteam.com
Made in USA
®
SPX Corporation, Rockford, IL 61109 USA
http://www.powerteam.com
Made in USA
