SPT WA-1288E, Instruction Manual

Page: 15 / 21

14
DRY (Dehumidifying) operation
Ensure the unit is plugged in and power is available.
1. Press the MODE button to select DRY mode.
2. Press the

/

button to set desired temperature.
3. If the unit is off, press ON/OFF button to start operation. Press ON/OFF
button again to stop operation.
TIMER operation
1. Press the TIMER button and the remote flashes “0.0” next to either Timer
-On or Timer-Off indicator.
2. Set desired time by pressing

to move forward or

to move backward.
- Press or hold the

/

button to move time by 0.5 hour increments, up to
10 hours, then by 1 hour increments up to 24 hours.
- The selected time will register in 3 seconds after setting.
3. After setting the timer for Timer-On or Timer-Off, check the Timer indicator
on the display panel is illuminated.
To Cancel: press the CANCEL button will remove all timer settings.
To change setting, repeat steps 1 to 3.
NOTE:
- When timer operation is set, the remote controller automatically transmits
the timer signal to the unit at the specified time. Therefore, keep the remote
controller in a location from which it can transmit the signal to the unit properly.
- Timer setting is limited to 24 hours.
NOTE: In Dry mode, fan speed is automatically controlled and cannot be
adjusted.
Operation
Setting the Clock
Set the clock before you start operating the air conditioner. The clock
will be displayed on the remote control panel regardless if air conditioner
is in use or not.
1. After batteries are inserted in the remote, the clock panel will display
“12:00”.
2. Press and hold the CLOCK button for 3 seconds, the time will flash.
3. Press

(forward) or

(backward) buttons to set time.
4. Each press of the button will move the time forward or backward by
one minute. Press and hold to move the time forward/backward in
10-minute intervals.
5. Once the right time is achieved, press the CLOCK button or release

/

button and wait for 5 seconds. The clock stops flashing, time
has been set.
Note: The clock time must be set before Timer feature can be set. If you
adjust the clock time after setting On/Off Timer, the remote will send the
adjusted timer information to the unit.
CAUTION: Static electricity or other factors (in case of extremely high
voltage) can cause remote controller clock to reset. If your remote
controller is reset (flashing 12:00), readjust the clock before operation.
COOL / FAN operation
1. Press the MODE button to select COOL or FAN mode.
2. Press the

/

button to set desired temperature (COOL mode only).
3. Press the FAN button to select fan speed: Auto, Low, Med or High.
4. If the unit is off, press ON/OFF button to start operation. Press
ON/OFF button again to stop operation.