5
Operating Instructions
Before initial use, charge the massager for a minimum of 8 hours.
Make sure power switch is in the OFF position before you connect pad, slipper or belt.
ELECTRODE PAD
1. Connect lead wire(s) by inserting the plug into the Left and/or Right channel outlets.
2. Connect electrode pads to lead wires by snapping them on. This should be done
before applying pads to the skin.
3. Place pads to treatment areas (such as shoulder or lower back), make sure pads do not
touch each other. Press down firmly and ensure a full and firm contact with skin.
4. Switch the power switch to ON position.
5. Press the M (mode) button to select desired massage mode.
6. Press the “+” button to increase massage intensity. Pressing the “-“ button would
decrease massage intensity.
7. During a massage session, pressing the center "
►
II" button would pause the
operation. Press again to resume.
8. Press the T (timer) button to set massage time, up to 60 minutes, in 10-minute
increments.
SLIPPERS
1. Snap on the lead wire to the slippers.
2. Connect the lead wire to unit’s left or right channel outlet.
3. Place feet into the slippers.
4. Switch the power switch to ON position.
5. Press the M (mode) button to select desired massage mode.
6. Press the “+” button to increase massage intensity. Pressing the “-“ button would
decrease massage intensity.
7. During a massage session, pressing the center "
►
II" button would pause the
operation. Press again to resume.
8. Press the T (timer) button to set massage time, up to 60 minutes, in 10-minute
increments.
MASSAGE BANDS
1. Snap the lead wires to massage belt.
2. Choose the appropriate band and affix to desired body part (waist, thigh, arm, etc).
3. Connect the lead wire(s) to unit’s left and/or right channel outlet.
4. Switch the power switch to ON position.
5. Press the M (mode) button to select desired massage mode.
6. Press the “+” button to increase massage intensity. Pressing the “-“ button would
decrease massage intensity.
7. During a massage session, pressing the center "
►
II" button would pause the
operation. Press again to resume.
8. Press the T (timer) button to set massage time, up to 60 minutes, in 10-minute
increments.