Installation Instructions:
1.
Unpack the ice maker and take out the attached documents and included parts, such as the
water inlet and drain tubes, ice shovel and gaskets.
2.
Install in the proper free-standing location. (See Before First Use)
3.
Connect one end of the drain tube to the water outlet connector on the ice maker. Connect the
other side to your drain or external condensation pump. (purchased separately from most
hardware or plumbing stores)
4.
Connect one end of the water inlet tube to the ice maker with the ¾” screw type connector.
Connect the other end to your water supply. The water pressure of the water supply pipe is 1.5
to 3 bar. (22 to 44 PSI)
5.
Insert the plug into the power supply socket.
Maintenance:
1: If the compressor stops for any reason like water shortage, ice full, power off or loss of power; do not
restart it right away. Please wait about 5-minutes.
2: Check the water inlet and drain line connectors regularly for any signs of cracks or wear.
3: If the ice maker will be unused for a long period of time, please switch off the power switch and wipe
the inner liner of the ice storage container. Also, drain the internal water tank via Drain Spout. (Part No.
9)
4: Unplug the unit by holding the plug, not the cord wire.
Specifications:
Model
Ice Making
Capacity*
(lbs/24hrs)
Rated
Voltage
Power
Consumption
(W)
Ice Storage
Capacity (lbs)
Dimensions (in)
SZB-20
66
110-120V /
60Hz
270
7
13 X 19.8 X 23.8
SZB-40
88
380
12
15.7 X 21.4 X27.6
3
.
.
* Based on water temperature at 50°F and ambient temperature at 59°F.
Summary of Contents for SZB-20
Page 7: ...Circuit Diagram 5 ...
