IMPORTANT SAFEGUARDS
Do not operate this lamp near a water source to avoid electric shock.
Do not dismantle.
Do not use with power supply other than 120V~60Hz.
Do not operate lamp in close proximity to flammable or combustible vapors, such
as aerosol spray, or where oxygen is being administered.
Do not cut or shorten the power cord.
Always unplug lamp before performing bulb installation, bulb replacement or
maintenance.
This product may cause interference with radios, cordless telephones or devices
that use a wireless remote control, such as televisions. If interference occurs, move
the product away from the device, plug the device or lamp in a different outlet or
move the lamp out of the line of the remote control receiver.
Unplug the lamp during lightning storms or when unused for extended period of time.
All moisture should be properly wiped away and dried prior to use.
Do not touch bulb when lamp is on or shortly after powering off. May cause burns.
Dispose of bulbs per local regulations.
IMPORTANT SAFEGUARDS
MAINTENANCE
Before cleaning, make sure lamp is powered off and unplugged. Allow sufficient time
for the bulb to cool down.
Periodically wipe the lamp with a soft damp cloth. Use a mild non-abrasive cleaner if
needed.
All liquid should be properly wiped away and dried prior to restoring power.
Do not use solvents or abrasive cleaners.
Lid
Light bulb
Lamp Shade
Bottom cover
Aluminum arm
Fixture
When installing
make sure “click”
is heard.
Fixture
When installing
make sure “click”
is heard.
Clamp
Power switch
Dimmer control
Attention
Do not use excessive force
when securing
screwdriver
Use a coin or flathead
Adjustment screw
If loose, use a screwdriver to tighten.
If loose, use a screwdriver to tighten screws
(use of other tools may cause damage)
PARTS IDENTIFICATION
height increased insole
SPECIFICATIONS
Model
Power Consumption
Power Supply
Dimension
Weight
Replacement Bulb
SL-824 T5
24W
120V / 60Hz
Approx. 22.4x27.56x19.67 (in)
3.17 lbs
HO-27W
Teminal
Notch
Socket
Bulb
BULB INSTALLATION / REPLACEMENT INSTRUCTIONS
Make sure lamp is powered off and unplugged from power source.
Wait until bulb is cool enough to handle. Bulb is hot immediately
after powering off.
1. Turn bulb 90 degrees and remove from socket .
Removal
Note: Handle with care, do not drop.
Do not replace anything other than the bulb.
Only replace with HO-24W bulb
Align base of bulb to notch on the socket. Turn bulb until a
1.
“click” is heard.
Installation
