3
ASSEMBLY INSTRUCTION
A. Base Assembly
1. Place Base on flat and sturdy ground.
2. Turn the Foot of Base Stand over and remove the
Lock Nut by turning counter-clock wise.
3. Insert Foot into base by
aim the clip on the Foot to
the groove on the base and
press down firmly.
WARNING
During installation, take caution to not damage the insulation
of power cord.
4. Replace Lock Nut and turn clock-wise until tightened.
NOTE: To disassemble:
1. Remove Lock Nut by turning counter-clock wise.
2. Lift the rear of the Foot up and pull backwards.
3. Replace the Lock Nut back onto the Foot.
Turn counter-
clock wise
Lock Nut
Bottom view of
base stand
Turn clock
wise to lock
WARNING!
Do not stand immediately above the unit
when adjusting height, may cause
collision to body.
WARNING!
Do not plug in power source before the
unit is fully assembled. May cause
electric shock.