OPERATIONAL OVERVIEW
1. Plug in the blender. Unit will beep once and all indicators flash once and dim, except
On/Off light remains flashing. Unit is in standby mode.
2. Place jar onto the base and secure lid. Note: unit will not operate if lid is not in place.
3. Touch the On/Off button and make selection of auto-program or manual.
4. Touch Confirm button to begin blend cycle. All programs have a preset time and will
automatically stop when done. Touch the Cancel button to stop cycle at any time.
5. When complete, remove jar and serve.
Caution
Always unplug power source before removing jar from the base.
When operating under the heating programs (porridge, soymilk, bisque and tea), the
glass jar gets extremely hot – DO NOT touch while operating and immediately after.
Handle with care and keep children away.
When using a heating program (porridge, soymilk, bisque and tea), add sweeteners
(sugar, agave, syrup, etc) at the end of the cycle to prevent burnt bottom.
Do not immerse jar in water or other liquid.
Use only cold or room temperature water – do not use hot water.
MANUAL MODE
1. Touch On/Off (Confirm) button.
2. Touch
▲
/
▼
button to set desired speed (1 to 9)
3. Touch On/Off (Confirm) button to begin blending.
4. Press Cancel or On/Off (Confirm) button to stop blending.
Speed can be adjusted as needed.
PULSE MODE
1. Touch On/Off (Confirm) button.
2. Touch and hold Pulse button, speed will start at 1 and increase automatically to 9 as
time progresses.
3. Release to stop.
TIMER SETTING
1. Touch On/Off (Confirm) button.
2. Use
▲
and
▼
buttons to set the time for unit to start (from 5 minutes to 24 hours, in 5-
minute increments).
3. Select function with the Program button.
4. Touch On/Off (Confirm) button to confirm settings. Display will show set time and begin
count-down.
Unit default is 1 hour. Each touch of the
▲
or
▼
button will increase/decrease time by 5
minutes. Touch and hold
▲
or
▼
button to increase/decrease by 10 minutes.
PRESET PROGRAMS
1. Touch On/Off (Confirm) button.
2. Touch Program button to select desired program.
3. Touch On/Off (Confirm) button to begin cycle.
Speed and time cannot be adjusted.
Each program has a preset time and will automatically stop at the end of the cycle,
Touch the Cancel or On/Off (Confirm) button to will stop the cycle.
Summary of Contents for CL-513
Page 5: ...PARTS IDENTIFICATION...
