5
OPERATING INSTRUCTIONS
•
Remove water tank by grasping the housing firmly and pull upwards.
•
Turn water tank over and turn the cap counter-clockwise to open. Fill with COOL tap water or
DISTILLED water. DO NOT USE HOT WATER.
•
Replace the fill cap by turning clockwise – do not over tighten.
NOTE: When carrying a filled water tank, place one hand under for support and do not carry by the mist
nozzle. Do not add fragrance or oil in the water – it will cause malfunction of the unit!
•
Place water tank back in place, making sure the tank is correctly aligned with the body.
•
Plug in power source and the Power Indicator will light up.
•
Press On/Off button, LCD panel will display settings and unit will begin to deliver mist output.
•
The temperature and humidity sensor is a detachable design. Affix it to the unit or nearby surface to
read ambient room temperature and humidity level.
•
Adjust the mist nozzle as desired (it turns 360
°
).
NOTE:
•
Once the water tank is in place, do not attempt to move the humidifier. If it has to be moved, unplug
the unit and drain water from the base before moving.
•
Once the water tank is in place or during operation, do not attempt to pick up the water tank. This will
cause excess water to collect in the base and reduce or cease mist output. To move the unit or add
water to the tank, first unplug power and drain water from the base.
•
Do not point the mist nozzle directly at the hygrostat. Do not spray or pour water on the hygrostat.
This will cause the hygrostat to become defective in reading the correct room humidity level. If wet, it
will read close to 100% humidity and unit will not produce any mist.
•
During the first few minutes of operation, some mist may escape from the crevice where the water
tank joins the base – this is normal and not a defect.
A. Adjust Mist Output
•
Press
or
−−−−
buttons to adjust mist output level (total 10 levels).
B. Change Room Temperature Degree Display
•
To change ambient temperature display from
°
C to
°
F (or vice versa): Press SETTING button
once and
°
C/
°
F will flash. Press
button to change the degree display.
•
Press SETTING button twice when done.
C. Ionizer
•
Press ION button to turn Ionizer feature on or off.
