SPT 15-AU50E, Operation Manual

Page: 7 / 13

6
Setting termination resistor by the DIP5 of the MODE
as follows:
Operation of the Keyboard
1. Select Address of the Speed Dome Camera [CAM]+[N]+[Enter]
Display: Current CamID 001
Description N –– No. of camera from 0 to 255
Function Select the address of the camera to be controlled. When the value N is in conformity with the
address of the Speed Dome Camera, it will be under control.
2. Set the Preset Position [[N]+[ Enter]
Display Preset No 001
Description N –– No. of preset position from 1 to 128.
Function Store current position and refer it as No. N position.
3. Call the Preset Position [CALL]+[N]+[ Enter]
Display Call Number 001
Description: N –– No. of preset position from 1 to 128.
Function Transfer the camera to the position of No. N preset position.
4. Cancel the Preset Position: [[N]+[OFF]
Display Preset No 001
Description N
––
No. of preset position from 1 to 128.
Function Delete the No. N preset position stored.
5. Set the Cruise Track (COP-2, PELCO-D, PELCO-P Available)
Enter the Status of Track Setting [SHOT]+[N]+ [ON] (N No. of track from 1 to 6).
Display Track = 01 Sum = 06
Description Track No.1 is currently setting, in which there are 6 preset points.
Edit Track Press [TELE] to edit down page and press [WIDE] to edit up page. Each track involves 16 preset
points and the running speed and the dwelling time of each preset position.
Display No. 01 Point 001
!
Description The 1st preset position in the track is 001.
Display No. 01 Speed 001
!
Description The speed of the 1st preset point in the track is the 1st class.
Display No. 01 Time 004
!
Description The dwelling time of the 1st preset point in the track is 4
Seconds
Speed Range 1 to 8 from the fastest to the lowest. Any speed outside the range will be referred as the 1st
class; the range of the dwelling time is 1 to 255.
When the No. N preset point is set as No. 0, then all preset points before the No. N preset point in the track
will be valid however all numbers of preset points afterward and their speed and dwelling time shall be set as
0 automatically.