SPRT
１１
as bellow:
*** Completed ***
Then quit the Hexadecimal Dump print mode.
2.7 Upgrade Mode
Holding down
【
FEED
】
button and turn on the power, the red indicator light
will flicker at 1 time/s, after 3 times then release the button. The printer
enters into Mode Choosing Status. Then press LF button 5 times and the
time distance between two times must be within 3s. The indicator will flicker
at 1s on and 1s off status. At this time, the printer enters into Upgrade Mode.
Chapter 3 Printing Driver Installation
Printing driver for POS58IV can be downloaded from the company of our
website. After downloading, the name of driver software is DRV211. During
installing driver software, choose printer model
“
58 thermal series
”
. About
other operation, pls refer to the detailed installation manual.
Appendix 1 Performance Index
·
Print method: Direct thermal
·
Print width: 57.5
±
0.5mm
·
Valid print width: 48mm
·
Print density: 8 dots/mm, 384 dots/line
·
Print speed: approx.70mm/sec.or 20 lines/sec.
·
Reliability:
Print head life: 50km
MCBF: 5 million lines
Using condition:
＊
Print 12
×
24 ASCII characters, print 50 lines each time, intermittent
print repeatedly
＊
Each dot-line printing at the same time should not exceed 25%, each
character line and one dot vertical printing repeatedly should not
exceed 11 times
＊
Use specified thermal paper
·
Thermal paper roll model: TF50KS
－
E
（
Japan paper co.ltd
）
AF50KS-E(JUJO THERMAL)
·
Thermal paper roll
PDF created with pdfFactory trial version
