1
0
Affixing the reflective film
Please use the following steps to affix the reflective film (
):
1. Mix a few drops of dishwashing liquid and some water, then set aside for later
use as a sealant.
2. Use a clean cloth to wipe the area on the glass where the reflective film will be
affixed.
3. Remove the protective film from the reflective film, and spray on the sealant
prepared earlier.
4. Lightly place the moistened reflective film against the windshield at the
location where the IHUD
’s projected image appears.
5. Sit in the driver
’s seat in the attitude you would
normally take when driving, and then make any
adjustments in the position of the reflective film
to obtain an optimal view.
6. With one hand, gently press a corner of the
reflective film and with the other hand use a
plastic scraper or other flat plastic object (such
an ATM card or credit card), and moving from the
center to the edges on each side, press out any
excess water or air bubbles and ensure there is no foreign matter trapped
under the film. (If there is, it will cause refraction interference.)
7. When the water has dried, use a clean cloth to wipe away any water marks on
the film.
Note:
Due to the optical properties of windshield glass, a head-up display that
performs perfectly in one car may exhibit ghosting artifacts in another car. If
you are experiencing this problem, it is recommended that you use the steps
described above to affix the reflective film.
The concept of HUD display contains would request the dark background of
image, therefore, switching the displaying APP or contains to night vision is
strongly recommended.
