19
Springfree™ Trampoline Model SF90E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 6.4
The disassembly is largely the reverse of the assembly steps. The following points should be noted:
TRAMPOLINE AND ENCLOSURE
DISASSEMBLY INSTRUCTIONS
Trampoline
To release each rod, push the clip lever
1.
towards the mat centre, and hold (Figures
1 and 2). Then push the ball end of the rod
towards the mat centre to disengage it
from the socket (Figure 3).
Move around the trampoline releasing
2.
every ifth rod.
Continue circling, releasing rods to the
3.
right of the gap until all rods are released
(by working at the right of the gap rather
than the left, your knuckles have more
clearance).
Once the mat is free, the frame can be
4.
disassembled.
WARNING: Never attempt to remove
an enclosure rod from its pocket or
disengage (unlock) the joiner while
the enclosure rod is under tension.
Tip:
One method to release a rod is to grip a pair
of rods with the right hand while releasing the
clip of the upper rod with the left hand. Now by
tightening the grip on the two rods the upper
rod ball slips out of the socket, while the rod is
still held irmly in the hand. From there, the rod
can be freed in a safe and controlled manner
(Figure 3).
WARNING: Treat any loaded rod with
caution. Keep your face well clear of
any loaded rod.
Release
Lever
Push lever
towards mat
centre to
release ball
Figure 1: The release clip on the mat itting
Figure 2: The release clip on the mat itting (view
beneath mat edge)
Figure 3: Preferred rod bending technique
WARNING: Do not attempt to
disassemble any frame components
before the mat and rods have been
removed. The frame and legs need to
remain assembled to carry the
rod loads.
Enclosure
First, remove the C-clips at the bottom of the
enclosure rods, then lift the bottom of the
enclosure rods out of their sockets in the frame.
Once the net is slack, pull the rods from the
pockets at the top of the net. The net will then
be lying around the trampoline as in Step 15,
Figure 15-B of the Trampoline and Enclosure
Assembly Instructions.
TO FOLD THE ENCLOSURE ROD
Remove the enclosure rod assembly from
1.
the enclosure rod socket in the base of the
trampoline.
Remove the rod assembly from the rod
2.
pocket at the top of the net.
Slide the white joiner up and fold the
3.
enclosure rods.
