Mains Pump Controller Quick Start Guide
V11M BPC
Step 2. Set Up - Power Up and Filling
Step 2. Continued
This message will display if the PSU develops
a fault. If voltage drops below 10.5V the unit will
shut down the pump.
Message
Description
If the unit is a 'One time
fi
ll' then pressing the up and down
arrows together and holding will stop the
fi
ll.
When the tank is full enough to activate the
fl
oat switch,
the controller stop the
fi
ll. The booster pump is stopped,
the
fi
lling solenoid valve is closed. The controller will go
back to displaying the PSU voltage.
If your V11M is con
fi
gured as a 'Fill on Demand' unit then
fi
lling will start automatically as soon as the
fl
oat switch
is in the down (normally closed) position.
The controller will turn on the
fi
lling solenoid valve and the
mains booster pump connected to the mains socket outlet.
This should allow water to
fi
ll your tank at a boosted
pressure by the mains booster pump.
On
fi
rst power up the controller displays the voltage of the
PSU in volts. It should be 12V (+/- 0.2V).
Turn on the controller by pressing the up or down button.
Keep the button held until the display lights up.
Connect your pump and liquid system to be controlled.
The controller is
fi
lling the tank. Booster pump
and solenoid
fi
lling valve are on.
If your V11M is con
fi
gured as a 'One time
fi
ll' unit then
fi
lling will start when you press and hold the up and down
arrows at the same time.
+
+
