Mounting The Control Panel:
To mount the Control Panel, use the template provided
Place the template on a plane or panel, perpendicular to the MAX Induction
Range, centering it to the range whenever possible.
The Control Panel cutout should measure 5 ¾”x 2 ¾”.
Place the Control Panel into cutout hole. Using the four (4) mounting
screws provided, secure the Control Panel into place.
Mounting Control Panel:
Testing Your MAX Induction™ Range:
Allow 1-2 hours curing time for the mastic adhesive. Check the leveling
screws to ensure even contact of range to granite. At this point you can
test the MAX Induction Range for conductivity.
Turn on the Induction Range and set the temperature to 150°F. The red
LED light should begin to blink.
Set a Stainless steel pan or server filled with water on top of the granite
directly over the induction range mounted underneath. The blinking LED
light should go solid. This means the induction range is reading the pan.
Get the most out of your range
. Always use induction-ready cookware.
See the Spring USA Website for a full line of induction-ready professional
cookware.
Model #
Voltage / Amps
Peak Power
Plug Type
SM-651SS
110-120 Volts / 5.4 Amps
650 Watts 50-60 Hz
NEMA 5-15
SM-653SS
230-240 Volts / 2.7 Amps
650 Watts 50-60 Hz
International Plug
How To Operate:
Your MAX Induction™ Range has been designed specifically to keep
foods warm. Your SM-651SS Range is a Warming or ‘Hold-Only’ In-
duction Range.
Always start by placing preheated foods into your serving vessels.
To Begin:
Press the On/Off Button
An LED light will indicate which temperature setting the range is op-
erating in (based on the chart shown below).
To change the temperature of the warming range, press the corre-
sponding button for the temperature you are trying to obtain
Your induction range will continue to warm until the set temperature
is reached
Once the set temperature has been reached, the unit will maintain at
that temperature
If the induction range senses a drop in temperature of the vessel
placed on top of it, it will start heating again, until the set temperature
is obtained
As a safety feature, your induction range will automatically shut
down if a vessel is not placed on it after two-minutes
Temperature ranges of your induction warming unit are as follows:
Note:
Our induction warming system is designed specifically for installation
under engineered granite that measures 1 cm in thickness. Use of non-
approved countertop materials immediately voids your warranty. Spring
USA is not responsible for poor performance or damage when ranges are
used in conjunction with non-approved materials. For a full list of com-
patible, approved countertop materials, see our website.
Our Induction Warming System has been designed and tested using
Spring USA Professional Cookware and Vessels. Spring USA cannot
guarantee the performance of other Vendors’ equipment being used with
our SmartStone™ Induction System.
www.springusa.com
800-535-8974
145 - 155° F
156 - 165° F
166 - 175° F
176 - 185° F
61 - 71° C
72 - 76° C
77 - 82° C
83 - 87° C
Low
Low-Med
Med-High
High
