SpotterRF SP-POWER-1 Quick Start Manual Download Page 2

FEDERAL COMMUNICATIONS 

COMMISSION STATEMENT

This  device  complies  with  part  15  of 
the  FCC  Rules.  Operation  is  subject  to 
the following two conditions:
(1) This device may not cause harmful 
interference  and  (2)  this  device  must 
accept  any  interference  received, 
including  interference  that  may  cause 
undesired operation.
Note:  This equipment has been tested 
and found to comply with the limits for 
a  Class  B  digital  device,  pursuant  to 
part  15  of  the  FCC  Rules.  These  limits 
are  designed  to  provide  reasonable 
protection 

against 

harmful 

interference 

in 

residential 

installation. This equipment generates, 
uses  and  can  radiate  radio  frequency 
energy and, if not installed and used in 
accordance  with  the  instructions,  may 
cause  harmful  interference  to  radio 
communications.  However,  there  is  no 
guarantee  that  interference  will  not 
occur in a particular installation. If this 
equipment 

does 

cause 

harmful 

interference  to  radio  or  television 
reception, which can be determined by 
turning  the  equipment  off  and  on,  the 
user is encouraged to try to correct the 
interference  by  one  or  more  of  the 
following measures:
--Reorient  or  relocate  the  receiving 
antenna.
--Increase  the  separation  between  the 
equipment and receiver.
--Connect the equipment into an outlet 
on  a  circuit  different  from  that  to 
which the receiver is connected.
--Consult the dealer or an experienced 
radio/TV technician for help.
Note:    This  equipment  complies  with 
FCC radiation exposure limits set forth 
for  an  uncontrolled  environment.  This 
equipment  should  be  installed  and 
operated  with  minimum  distance 
20cm  between  the  radiator  and  your 
body.  This  transmitter  must  not  be 
co-located  or  operating  in  conjunction 
with any other antenna or transmitter.
RF Exposure Information:  To comply 
with 

FCC/IC 

RF 

exposure 

requirements  for  mobile  transmitting 
devices,  this  transmitter  should  only 
be used or installed at locations where 
there  is  at  least  20  cm  separation 
distance  between  the  antenna  and  all 
persons.

Troubleshooting

Verify the cable from the radar 
to the injector  and the cable 
from the injector to the 
computer have solid 
connections, Cables should 
have been tested (Step 2 
previous page) Remove 
connections and reconnect 
them all.  

Confirm only cables 
connected to the 
injector/switch are one for the 
radar and one for the 
Laptop/PC.  Remove all 
others.  

Confirm the computer IP is set 
to DHCP.

Access the radar on 
169.254.254.254 using Google 
Chrome or Mozilla Firefox.

Power cycle the radar and wait 
at least one minute before 
trying to access 
169.254.254.254 again.

Step 9

 

Once the UI is visible, select the “Tracker” tab 

in the top right corner. 

The following page should be displayed:

Tracks from the radar will be displayed on this page in real time.

Call SpotterRF 

Tech Support at 

813-200-7227

Quickstart Guide - SpotterRF Radar

Reviews: