mini profile zoom NO
ACCESSORIES:
-
colour filter frame
: insert into the guides
⑥
verify-
ing that the locking clip
⑦
is correctly positioned.
-
gobo holder
: slide forward the slot cover
⑨,
insert
the gobo holder and slide backward the cover to lock
the gobo holder in position and avoid light spill
Foreseen gobo type: “M” size.
ELECTRICAL CONNECTIONS
The luminaire is designed to operate with a 100V to
240V supply, 50-60Hz, according to the lamp used.
Before and during the installation, make sure you
follow the guidelines below:
• Always check the earth wiring for the line being used.
• Ensure the lamp voltage is the same as the mains one
• Do not use lamps other than indicated on the lamp
table
• There are no fuses inside the units, if it is necessary
they should be installed in the mains
• The luminaires can be connected to a dimmer
5
DESCRIPTION OF THE LUMINAIRES
Referring to images on page 2:
①
Suspension yoke
②
Knobs for opening lamp cover
③
Handle for tilt regulation
④
Levers for framing shutters adjustment
⑤
Knobs for lens adjustment: focus and zoom
⑥
Accessory guides
⑦
Accessory locking clip
⑧
Lenses cover
⑨
Gobo slot sliding cover
INTRODUCTION
The luminaire you have bought complies to 2006/95/EC,
2004/108/EC and 2011/65/EU European Directives.
The labels on the side of the luminaire list the following
information:
• model
• mains supply voltage (V)
• lamp wattage (W)
• IP protection index
• maximum allowed ambient temperature in °C
• maximum temperature of the body in °C
• minimum distance from flammable surface
• information to find the position 0° of the luminaire:
when the tip of the arrow points upwards
• maximum tilt angle range. These limits, imposed by
the lamp manufacturer, should not be exceeded as
they would reduce the luminaire’s useful life or lead
to its deterioration.
INSTALLATION
• The luminaires are intended for professional use only
so they have to be installed and used by qualified
technicians.
• The products are intended for indoor use:
consequently they have to be protected from humidity
and rain, if used in different conditions (IP 20)
• Do not mount the luminaire on or near a flammable
surface
• Please note carefully the notes written on the labels
of the luminaires.
• Do not forget to connect a safety rope, if required by
local country safety regulations
• The luminaires can be either suspended, or mounted
on a stand, by turning the yoke upside-down.
WARNING: The luminaires must always be
earthed
WARNING: replace immediately the lamp
and/or the lenses if visibly damaged,
even if still working.
