ASSEMBLY AND INSTALLATION INSTRUCTIONS
10
Assembly and Installation Instructions
During periods of non-use, this trampoline and trampoline enclosure can be easily disassembled and
stored by reversing the order of installation.
At least two people are required to assemble the trampoline and trampoline enclosure.
Protective gloves
must
be used during assembly to avoid injuries during installation.
Protective goggles must be worn to avoid injuries to the eyes.
For appropriate use of the trampoline, please assemble the trampoline in a location that meets the following
conditions:
Adequate overhead clearance is needed. A minimum of
26.25 ft (8 meters)
from ground level is
recommended. Provide clearance for wires, tree limbs and other possible hazards.
ALWAYS ensure the trampoline is on level ground with a minimum of 2 meters clear space from any
structure or obstruction such as fence, garage, house, overhanging branches, laundry lines or electrical
wires.
Place the trampoline on a flat and level surface before use.
Do not install this trampoline on hard surfaces. Suitable surfaces include grass or sand.
Use the trampoline in a well-lit area. Artificial illumination may be required for shady areas.
The trampoline should be installed in an area where access can be restricted from unauthorized and
unsupervised use.
Ensure there is nothing beneath the trampoline that could cause injury or obstruct movement of jump mat.
The trampoline enclosure is only to be used as an enclosure for a trampoline of a size for which the
enclosure is designed.
The owner and supervisors of the trampoline are responsible to make all users aware of practices
specified in the use instructions section.
Users may become entangled in or strangled by loose cords or in gaps between trampoline and enclosure.
Keep enclosure tightly fastened
to the trampoline in accordance with the manufacturer’s instructions.
Failure to properly assemble and maintain a tight, secure trampoline/enclosure boundary may result in
serious injury, strangulation, or death.
If you do not follow these guidelines, you increase the risk of injury or death.
PRIOR TO ASSEMBLING
Before assembly, please ensure that you have all the parts required to assemble the product. If you are
missing any parts, please contact our Customer Support agents.
Please do not use unauthorised Sportspower parts to assemble the trampoline. This may damage the
integrity of the product and will void the manufacturer’s warranty.
DO NOT use electric power tools to tighten or loosen bolts and screws as this can damage the
hardware.
All nuts and bolts must be checked for tightness and if necessary must be retightened.
All spring-loaded (pit pin) joints must be checked to see that they are still intact and cannot become
dislodged during play.
Check all coverings for bolts and sharp edges and replace them if necessary.
If self-locking nuts are used, it should be noted that these are only suitable for one assembly and must
therefore be replaced.
Review all steps before assembly and read all precautions before using this
product. Failure to do so can result in serious injury or death.
