•
coat.
Sheet 2 of 2
Sheet 2 of 2
Sheet 2 of 2
Sheet 2 of 2
Hardware: Stainless steel tamper risistant.
Tighten until lock nut is flush with thread end of bolt.
ladder, and fasten with 3/8" lock nut.
bolts, no washer on the inside of the ladder, through
and tighten. Fasten top portion of handrails with 3/8"
See the Top Down View for placement.
•
Make sure arch entry clamps are level to each other
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
Step Ladder Plan:
Step Ladder Plan:
Step Ladder Plan:
Step Ladder Plan:
•
Connect these with (4) 3/8" x 2-1/4" button head
holes in the bottom side of stepladder.
x 3/8" set screw.
•
SPECIFICATIONS:
SPECIFICATIONS:
SPECIFICATIONS:
SPECIFICATIONS:
The Step Ladder connects to 3', 4', 5', and 6' deck top
and bottom angle connection to deck and ground with
ground legs. Arch entry wall is 1-3/8" OD steel with 2
attachmet brackets to connect
INSTRUCTIONS:
INSTRUCTIONS:
INSTRUCTIONS:
INSTRUCTIONS:
Temporarily lay the angle-lip of stepladder onto deck
•
so that there is a 90- degree connection. Center it over
the 15" appart holes on top of deck.
Mark holes on the ground for the two bottom legs
•
(20" apart).
Remove ladder and dig two holes 12" wide and 24"
•
deep.
Connect the bottom leg with (2) 1-1/4" x 3/8" button
•
head bolt, washer on top and lock nut on bottom.
Install (2) re-bar in bottom leg pipes and install
•
assembly into ground holes.
Tip up to deck and connect to deck holes (on top of
•
deck) with (2) 3/8" x 1-1/4" button head bolts, one
washer on top and one on bottom, and lock nut.
Connect the arch entry to the center of the posts
•
with (2) attachments brackets with gaskets between
the post and bracket. Then to the deck on the bottom
through the plates.
Connect the left and right handrails so that the top
•
end (end with no holes) goes into the pipe sleeves
on the arch entry.
Line up the bottom of the handrail (2 per side) to the
Event: Steps have a 7-1/4" step and 8-1/2" riser made of
#9 ga.
Entire ladder is PVC coated after fabrication.
Paint shall be electrostatically applied oven cured powder-
Touch up any marred paint surfaces.
Periodically check harware for integrity and tightness.
1
STEP LADDER 3', 4', 5', 6'
STEP LADDER 3', 4', 5', 6'
STEP LADDER 3', 4', 5', 6'
STEP LADDER 3', 4', 5', 6'
5
4
3
2
912-323, 902-234,
912-323, 902-234,
912-323, 902-234,
912-323, 902-234,
912-235, 912-326
912-235, 912-326
912-235, 912-326
912-235, 912-326
Summary of Contents for Independent Spiral Slide
Page 1: ......
