902-875 ROCK CLIMBING TUNNEL
INSTALLATION INSTRUCTIONS
WWW.SPORTSPLAYINC.COM
3
SPE C I F I C ASSE M B L Y INST RU C T I O NS
1.
%HJLQE\GLJJLQJKROHV´LQGLDPHWHUDQG´
deep based
off of the dimensions on the side view footing page at the back
of these instructions.
2.
,QVWDOOWKHOHJVLQWKHKROHVE\ILOOLQJWKHKROHVZLWK´RI
concrete.
3.
Attach the side panels to the legs with one sloped end of the
panel pointing to the left on one side of the structure and he
other sloped end pointing to the right on the other side of the
structure by using the 5/16x1 3/4 Buttonhead bolt and 5/16
washer on the front side of the panel and by using the 3/8
washer and 5/16x1 Buttonhead nut on the back side of the
panel. (view detail drawing on the first page)
4.
Attach the top panel as shown using the 5/16x1
¾
Buttonhead
bolts and 5/16 washers on the top side of the panel and 5/16x1
Buttonhead nut and 3/8 washer on the bottom side of the panel.
5.
Attach the rocks to the panels using the 5/16x3/4 Buttonhead
bolt in the large hole on the front of the rock and the 1/4x1
Buttonhead bolt in the small hole on the front of the rock and
the 5/16x1 Buttonhead nut with the 3/8 washer in the large hole
on the back side of the panel and the
¼
tee nut in the small hole
on the back side of the panel. ROCKS MUST BE PLACED
ON PANELS IN CERTAIN ORDER. Refer to the following
rock layout page to determine which rocks should go were.
6.
Install middle support bracket along edge of top plastic piece.
Place directly between support legs on the under side of plastic,
mark and drill holes, then attach bracket using (2) 3/8
´
x 1
´
bolts with 3/8
´
washers on top side and (2) 3/8
´
t-nuts on
bottoms side.
