Accessible Square Table with Standard Frame
602-671 & 602-672
Important
Please keep a copy of these instructions in your files. There is
important replacement part information in them that will assist
you in the event a part is ever needed.
Assembly Information
Read all assembly instruction before starting assembly.
Verify that all parts were received by comparing the parts
received to the component list on page one.
If your product mounts to something (surface mount, in ground
or wall mount) you will assemble the entire product before
drilling holes or mounting frame in order to ensure proper
layout.
CONTACT YOUR DISTRIBUTOR ABOUT ANY PARTS YOU ARE
MISSING. You must report missing parts within 10 days of
delivery.
Hand-tighten all bolts during the initial assembly (unless
specifically told to tighten completely in the instructions). Once
the unit is fully assembled and square you should completely
tighten them.
Other than when a specific step in the assembly instructions
specifies “to not apply LocTite, we recommend applying a small
amount to all assembly bolts.
General Maintenance
It is recommended that you inspect the product monthly for
loose bolts and broken parts. If replacement parts are needed
please refer to these instructions for part numbers and
descriptions then call your distributor to order replacements.
NOTE: Do not completely tighten any bolts until the unit
is completely assembled.
Assembly Instructions
1. First assemble the frame by connecting two bench legs (3) to the
cross brace (4). Positioning the legs at a 45 degree angle and
overlap the connection tabs. Then insert a 3/8 x 1 ½” button head
bolt (5) and 3/8” washer (8) through the tabs on the bench leg and
into the hole on the vertical tab of the cross brace. Attach a 3/8”
lock nut (9) to the bolt and hand tighten. Refer to
Detail A
on the
first page.
2. Repeat step 1 to the remaining bench legs.
3. Lay the table top face down on a piece of cardboard or cloth.
Attach the table top (2) to the bench legs (3) using the eight 3/8 x
1 ¼” button head bolts (7), 3/8’ washer (8) and 3/8’ lock nut (9).
Insert bolt through the washer, bench leg and table frame. Attach
the nut but do not tighten at this time. Refer to
Detail B
on the
first page for this step.
4. Attach all seat planks (1) to the bench legs (3) by inserting the 3/8
x 1” button head bolt (6) and 3/8” washer (8) through the bottom
of the bracket on the bench leg (3) and into the factory installed
nut on the bottom of the bench plank (1). Refer to
Detail C
on the
first page for this step.
5. Starting with one side, square the bench legs with the table and
tighten all bolts. After all the bench legs have been tightened,
square table top and tighten bolts completely.
6. Finally, inspect the entire picnic table to ensure all bots are
completely tightened.
Version: ECSquare_v1
www.sportsplayinc.com
2
