571-106 Tennis Post / 571-106C (Powdercoated) (pair)
Page 2 of 2
Rev. 05/08/08
GENERAL ASSEMBLY INSTRUCTIONS:
Check all parts and hardware against the packing list to insure you have
received everything needed to assemble this product.
Check each part carefully and remove any sharp edges or projections that may
have been caused in shipping. Contact your distributor with notification of
any missing or damaged parts. Contact must be made within ten days of
receipt of your order.
After assembly is complete, all threaded ends of bolts protruding beyond nuts
should be cut off and/or peened over to remove any sharp projections. Also,
there are a few extra washers supplied to be used as spacers where needed to
prevent any thread projection beyond the nuts.
SPECIFIC ASSEMBLY INSTRUCTIONS:
STEP #1:
Assemble Eyebolts in posts as shown in illustration using:
146-520
Eye
Bolt
316-501 Flat Washer (goes on Nut side of post)
216-501
Hex
Nut
STEP #2:
Attach the Net Reel to the post as shown in illustration using:
116-516
Hex
Bolt
316-501 Flat Washer (goes on Nut side of post)
216-501
Hex
Nut
STEP #3:
Locate and dig footing holes and Net Anchor Hole as indicated
on the Footing diagram below.
STEP #4:
After checking and tightening all bolted connections, prop the
posts and the net anchor to the indicated depth and pour the
concrete, using 7 – 80lb. Bags of pre-mix. The top of the
concrete should be crowned for drainage. Allow at least 48 hours
for the concrete to harden.
MAINTENANCE INSTRUCTIONS:
Check periodically for loose bolts or broken parts. Replace any
broken or damaged parts immediately.
SportsPlay Equipment, Inc. 5642 Natural Bridge, St. Louis MO 63120
21’3”
42’6”
