301-141 RABBIT HUTCH (Perm.)
Page
3
REV 11/17/09
301-141.I.CC.1109.2
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the parts and hardware with the packing list to be sure you have received
everything needed to assemble this product. CONTACT YOUR LOCAL DISTRIBUTOR WITH
NOTIFICATION OF ANY MISSING OR DAMAGED PARTS. Contact must be made within ten days of
receipt of your order.
Only hand-tighten nuts & bolts on initial assembly. Final tightening should be done
EVENLY after final assembly when unit has bee plumbed and leveled.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or replace
immediately.
SPECIFIC ASSEMBLY INSTRUCTIONS:
NOTE:
All threaded ends of bolts protruding beyond nuts must be cut off and/or peened
to eliminate sharp edges. No more than two threads should extend beyond face
of nut. All washers, “T” nuts, and other fastener hardware used on round pipe
or tubing must be hammered down to conform to the curved underlying surface to
eliminate catch points.
STEP #1: Place 113-306, 2-Ring Ladder onto ground with ring that has (4) holes in it
facing upwards.
STEP #2: Place 113-044 shell on top of 2-Ring Ladder so that the ladder will be beneath
the shell.
STEP #3: Attach 2-Ring Ladder to Shell using 5/16” x 1-1/2” Button Head Bolts, 5/16”
Lock Washers, and 5/16” Button Head Nuts. Tighten Button Head Bolts and Nuts
with 3/16” Socket Key. See Detail A at the bottom of this page.
STEP #4: Turn shell upside down and attach 113-610 Shell legs to Shell using 3.8” x 2”
Hex Head Bolts with 3/8” Lock Washers. See Detail B at the bottom of this
page.
STEP #5: Check and tighten all Bolts and Nuts.
STEP #6: Turn shell over onto its legs and position, mark and dig holes. See footing
drawing on page 2.
STEP #7: Use suggested bracing method on page 2 for holding completed assembly in
position while pouring concrete into footing holes.
STEP #8: Allow at least 48 hours for concrete to harden before using equipment.
STEP #9: Attach Warning Label and Manufacturer’s Identification Label to a clean
surface. The Labels should be attached in a location where they are clearly
visible and legible and away from normal hand and foot placement areas. The
Labels must be replaced if the become illegible, destroyed or removed. Contact
your Distributor for replacement Labels.