801-412-H See Saw 8 Seat
Page
3
Rev. 09/10/2010
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
SPECIFIC INSTRUCTIONS:
Car tires (not furnished) or some other shock-absorbing material should be
embedded in the ground beneath the seats to minimize the risk of injury due
to abrupt contact with the ground. Also, lengths of standard 2 x 4’s can be
easily positioned between the pipe rails to prevent children from putting
their feet between the rails.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or
replace immediately.
ASSEMBLY AND INSTALLATION:
NOTE:
All button head nuts are placed on the pipe side of the spots where
attached and the lock washers are placed on the Bolts. DO NOT tighten
nuts more than hand-tight until entire assembly is completed.
STEP #1: Assemble frame by first attaching one end leg to 8’ long top rail using
elbow. Tighten with set screws on elbow. Slide fulcrum over top rail to
elbow by leg, slide sleeve on top rail so holds fulcrum in place.
Tighten sleeve with set screw to bottom of top rail. Slide next sleeve
onto top rail, then fulcrum, then another sleeve. Position so second
fulcrum centerline is 3’8” from centerline of first fulcrum. Tighten
sleeve set screws to hold fulcrum in place. Then add T-Fitting and
second leg to top rail securing 6’4” from first leg. Slide sleeves and
fulcrums onto top rail, again positioning third fulcrum 3’8” from
previous fulcrum. Repeat process until entire frame is assembled, with
last elbow acting as the sleeve for the last fulcrum. DO NOT attach see-
saws at this time.
STEP #2: Using assembled frame as your template, mark and dig footing holes.
STEP #3: Prop in holes, leaving 15-18” distance from resilient surface to top of
frame, plumb, level and pour concrete. Allow at least 48 hours for
concrete to harden.
STEP #4: After concrete has hardened, attach the rest of the equipment. Use the
5/16” x 2 1/4” button head bolts, lock washers and button head nuts to
attach the long pipe supports to the fulcrums. Use the 5/16” x 3” button
head bolts, lock washers and button head nuts to attach the seat and
handle to the pipe supports. Use Threadlocker on all button head
fasteners. Drive pipe plugs into the open ends of the pipe supports.
STEP #5: Attach Warning Label and Manufacturer’s Identification Label to a clean
surface. The labels should be attached in a location where they are
clearly visible and legible and away from normal hand and foot placement
areas. The labels must be replaced if they become illegible, destroyed
or are missing. Contact your SportsPlay distributor for replacement
labels.