801-212-H See Saw 4 Seat
Page
3
Rev. 09/21/2010
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
SPECIFIC INSTRUCTIONS:
Car tires (not furnished) or some other shock-absorbing material should be
embedded in the ground beneath the seats to minimize the risk of injury due
to abrupt contact with the ground. Also, lengths of standard 2 x 4’s can be
easily positioned between the pipe rails to prevent children from putting
their feet between the rails.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or
replace immediately.
SPECIFIC ASSEMBLY AND INSTALLATION:
NOTE:
All button head nuts are placed on the pipe side of the spots where
attached and the lock washers are placed on the Bolts. DO NOT tighten
nuts more than hand-tight until entire assembly is completed.
STEP #1: Assemble frame by first attaching one leg to top rail using elbow.
Tighten set screws on elbow, slide fulcrum over top rail to elbow by leg.
Slide sleeve on top rail so holds fulcrum in place. Tighten sleeve with
set screw on bottom of top rail. Slide next sleeve onto top rail, then
fulcrum, then attach elbow for second leg. Slide fulcrum back against
elbow, then sleeve against fulcrum. Tighten sleeve with set screw. DO
NOT attach see saws at this time.
STEP #2: Using assembled frame as your template, mark and dig footing holes.
STEP #3: Prop in holes, leaving 15-18” distance from resilient surface to top of
frame, plumb, level and pour concrete. Allow at least 48 hours for
concrete to harden.
STEP #4: After concrete has hardened, attach the rest of the equipment. Use the
5/16” x 2 1/4” button head bolts, lock washers and button head nuts to
attach the long pipe supports to the fulcrums. Use the 5/16” x 3” button
head bolts, lock washers and button head nuts (rear of seat) to attach
the seat and handle to the pipe supports. Use Threadlocker on all button
head fasteners. Drive pipe plugs into the open ends of the pipe supports.
STEP #5: Attach Warning Label and Manufacturer’s Identification Label to a clean
surface. The labels should be attached in a location where they are
clearly visible and legible and away from normal hand and foot placement
areas. The labels must be replaced if they become illegible, destroyed
or are missing. Contact your SportsPlay distributor for replacement
labels.