581-367 Heavy Duty Tripod Tire Swing
Page
4
Rev. 04/25/2005
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
STEP #2:
Footing holes may be marked out & dug from footing layout,
however, it is generally easier to position Swing in proper
location, mark holes, then move Swing to one side & dig holes.
STEP #3:
Stand Swing upright onto Legs & brace in footing holes so that
24” of pipe will be under intended level of resilient surfacing.
STEP #4:
Using S-Hooks, attach tire seat to one end of chain. Close the
S-hooks to within .034” (1/32”) using S-hook pliers or pounding
with a hammer. Attach other end of chains to swivel.
STEP #5:
Attach swivel to Top Rail. SEE STEP #4.
STEP #6:
Attach Assembled Tire Seat to Swivel.
NOTE: Be sure to keep the grease fitting filled with grease.
STEP #7:
Plumb & Level entire unit. Tighten all nuts & bolts until lock
washers are flat. Use short length of pipe on end of Socket Key
to add leverage when tightening Socket Set Screws. Pour
concrete. Wait 48 hours before removing braces, applying
resilient surfacing and using equipment.
STEP #8:
Attach Warning Label and Manufacturer’s Identification Label to a
clean surface. The labels should be attached in a location where
they are clearly visible and legible and away from normal hand
and foot placement areas. The labels must be replaced if they
become illegible, destroyed or are missing. Contact your
SportsPlay distributor for replacement labels.
