561-443 Heavy Duty Football Goal - Pair
Page 2 of 2
Rev. 05/21/08
ASSEMBLY AND INSTALLATION:
NOTE:
All threaded ends of bolts protruding beyond nuts must be
cut off and/or peened to eliminate sharp edges. No more
than two threads should extend beyond face of nut.
All washers, “T” nuts, and other fastener hardware used on
round pipe or tubing must be hammered down to conform to the
curved underlying surface to eliminate catch points.
DO NOT tighten nuts more than hand-tight until entire
assembly is completed.
STEP #1:
Mark and dig footing holes
STEP #2:
Assemble Goal posts
STEP #3:
Pour footings using:
60 – 80lb. Bags Pre-Mix Cement – 15 bags per hole.
Place bricks or old cement chunks below the posts to allow
wet cement under the post. Be sure to maintain the height
and distance between posts, per diagram on page 1, for each
goal post.
Be sure to ‘cone’ the top of the pour for drainage.
STEP #4:
Plumb and level posts.
STEP #5:
Brace posts until cement is dry.
NOTES:
Wait 48 hours for concrete to harden before using unit.
DO NOT install where overhead electrical wires are present.
MAINTENANCE INSTRUCTIONS:
Check periodically for loose bolts, broken parts and replace
immediately.
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
