Inspection and measurement
Item:
Rechargeable battery
Testing item:
Drive board battery charging voltage measurement
Method: 1. Set the volt meter to voltage setting at above 50V; put black and red leads to drive board battery wiring housing.
2. Pedaling above 60RPM, the LED2 charge indicator on drive board should light up and the volt meter reading
should be > 17.2V.
3. If the reading is not > 17.2V, then possible causes are: A. Battery voltage is too low B. Drive board battery fuse
burnt C. Bad drive board
4. If the battery is too low, use adapter to help charging
4-8-1
Battery wire housing
蓄電池充電孔
LED2 Charge
indicator
Battery 6V*2=12V
Battery fuse 3A
Battery fuse 3A
Battery Charger
Summary of Contents for C575R
