Hack attack
™
BaseBall PitcHing MacHine
sPorts attack, llc.
•
800-717-4251
•
sportsattack.com
9
Shutting Down
ShUTTINg DOWN
tuRnInG HACK AttACK “OFF”
1. Set each speed control dial to “0”.
2. Turn the on/off switch “OFF”.
3. Unplug Hack Attack from the power source.
PuttInG HACK AttACK AWAY
1. Be absolutely sure that the throwing wheels have completely stopped turning.
2. See Figure 7 at right:
a. Turn the elevation adjustment counter-clockwise until the throwing head is all the
way down against the elevation control nut.
b. Push and hold the travel lock all the way in.
c. Turn the elevation adjustment clockwise until the throwing head is held tightly
against the travel lock. Tighten just enough to secure the throwing head. It is not
necessary to over tighten.
3. Using the rear leg as a handle, tip Hack Attack up and over onto the wheel guard.
4. Remove (unsocket) both front legs and store by inserting in the travel storage sockets.
5. See Figure 8 at right:
Again, using the rear leg as a handle, tip Hack Attack back until machine can be
comfortably rolled on the travel wheels. Hack Attack can now be rolled and
maneuvered off of the field.
6. To transport Hack Attack in a car, remove the throwing head:
a. Be sure the travel lock is engaged and the throwing head is tightly secured to
the yoke.
b. Loosen the horizontal swivel control. Turn it counter-clockwise until the throwing
head is free to lift out of the swivel.
c. Lift the throwing head straight up and clear of the undercarriage.
SUGGESTION: The throwing head, while awkward, can be carried for short distances
by gripping the top section of the wheel guard and balancing the piece against your
thighs as you walk.
d. To prevent damage in transport, rest the throwing head on the wheel guard and yoke;
motors should be down, and the control panel pointing up.
Figure 7
Secure the Travel Lock
Figure 8
Maneuvering
Storing Legs in Travel Socket
ELEVATION
CONTROL
LOCKING
TAB ON
THROWING
HEAD
TRAVEL
LOCK
USE TRANSPORT
LEG AS A HANDLE
TO MANEUVER